Description

White Ensign Models 1/350 Prinz Eugen Photoetch Enhancement Parts

White Ensign Models 1/350 Prinz Eugen Photoetch Enhancement Parts is designed for the Trumpeter kit.

The White Ensign models Photoetch add-ons makes your model ship museum quality.

The first fret contains:

• Stock 3-Bar Railing
• Handrails for Superstructure
• Handrails for Bulwark Tops
• Railings (Aft Conning Tower Deck)
• Railings (Landing C18)
• Railings (Lower Superstructure Aft)
• Railings (Lower Superstructure Fwd)
• Railings (Shaped for Foc’s’le)
• Railings (Bow)
• Railings (Lower Superstructure Mid Aft)
• Railings (Lower Superstructure Mid Fwd)
• Railings (Superstructure Fwd 105 Deck)
• Railings (Aft Superstructure Deck A1)
• Railings (Hangar Well Edges)
• Inclined Ladder Replacement B24
• Inclined Ladder Replacement B23
• Inclined Ladder Replacements F6
• Inclined Ladders Fore & Aft Superstructure
• Vertical Ladder Stock
• Cable Reel Replacements G36
• Watertight Doors
• Watertight Hatches

The second fret contains:

• Aircraft Catapult
• Catapult Pulley Wheels
• Catapult Servicing Platform
• Aircraft Launch Cradle
• Sea Boat Boarding Platforms
• Turmmast Rear Yardarm Footbars
• Mainmast Upper Platform Yardarms
• Funnel Vent Boat Cradles Port (Early Fit)
• Funnel Vent Deck

General instructions:

• Do not remove the etched parts from the fret until you are ready to use them.
• Before assembly, soak the etched parts in a suitable solvent, such as white spirit, to de-grease the surfaces for painting.
• Cyanoacrylate adhesive (super glue) or contact adhesive such as Elmers white glue may be used. These can be applied with a pin or piece of stretched sprue.
• When removing parts from the fret, place the fret on a hard surface, such as a smooth ceramic tile, in order to prevent parts bending whilst cutting through the holding
  tabs. We suggest using a #11 type of modelling knife blade for this purpose.

Accordingly, we suggest you purchase our Photoetch Bender Tools for easy assembly.