Description
Sherline 67130 Stepper Motor (without plug)
Sherline offers machines in CNC-ready
configuration for those wishing to supply their own stepper motors
and controls. We also offer linear and rotary motion controllers
that will drive an individual stepper motor without the need for a
separate computer or driver. Sherline motion contollers come with
stepper motors, but for those who wish to purchase additional
motors or wish to buy them from us to put together their own CNC
system, we offer a high quality stepper motor.
More detailed manufacturer specifications
can be found by following the link near the bottom of this
page.
- Frame size: NEMA #23
- Shaft: 1/4″ diameter, dual
shafts - Torque: 100+ oz. in.
- Voltage: 3.2 V.
- Current: 2 A
- Step Angle: 1.8° (200
steps/rev)
Sherline stepper motors have shafts at
both ends so that a handwheel can be used for manual control if
desired. Flats are ground onto each end of the shaft to accommodate
set screws for handwheel and coupling. If a stepper motor is to be
used with a Sherline motor mount, the shaft going into the coupling
should have a flat machined or ground on it where the set screw
bites into it. If this is not done, the point of the set screw can
upset the shaft surface sufficiently to make it impossible to
remove the coupling.
This stepper motor has six wire leads and
does NOT include a plug.
